ip Camera Controller 1.0


Category: Photography
Price: $19.99 (iTunes)

Description:

This Application allows you to view feed from multiple Axis cameras on the iPhone or iTouch. Also, if your camera is equipped with Pan/Tilt/Zoom, the iPhone or iTouch can be used to control the cameras ptz controls.

If you see the perfect shot while viewing the camera feed, you can save a snapshot off to the photo gallery.

When you initialize your camera set up, you can load a picture from the photo gallery to identify the camera that you are configuring in the table selection view.

If PTZ mode is selected, a small red crosshair will appear on the screen. By placing your finger on this crosshair and sliding your finger across the screen you invoke the pan and/or tilt functions on the camera. When you put two fingers on the surface, two round circles appear under your fingers. This action invokes the zoom function on the camera.

Initializing the Application - After you initially download the application there will be NO table entries. To enter your camera information for the first time select EDIT and then +. This is the Configuration page.

Configuration Page - In this page you first enter the label associated with your camera location. This will appear in the table along with your picture. Next enter you DynDNS or TCP/IP address, port and use ID/Password information. If you select the camera icon you can select a particular picture from your photo gallery. We often configure a camera, go to the feed page and take a snap shot. We then reedit the camera information and load the picture we just took for the table entry.

Initial Page - Configured Cameras. This is a table list of the cameras that you have configured. By selecting the chevron on the right, you select the feed from that particular camera.

Individual Camera Page - NON- PTZ - In this page you are viewing the direct camera feed. The camera icon on the page allows you to take a snapshot and store it to the photo gallery. Within this page you can pan around the image using finger gestures.

PTZ Camera Page - If you have configured a PTZ camera, the feed page will have two additional buttons at the bottom - Normal and Pan/Tilt/Zoom. In normal the page reacts just as described above. When you select Pan/Tilt/Zoom you will see a small red crosshair appear and the entire view of the camera is displayed. Placing your finger on the crosshair and dragging it across the screen will causing the camera PAN and Tilt functions to be invoked and the camera will move (give it a few seconds to refresh the display). If you place BOTH fingers on either side of the crosshair, two circles appear (under your finger tips). With the two finger gesture you can zoom in (pulling your fingers closer) or zoom out (pulling your fingers apart). In PTZ mode you can flip between Normal and PTZ by just touching the buttons.
ip Camera Controller



更多...